Contact us
+34 943 82 00 82

Skip to content. | Skip to navigation

Equipment for Quality Control and R&D+i

Cylindrical Mandrels

This cylindrical mandrel bend tester consists of a robust frame which has a bending lever, with height adjustable rollers and a sliding vice for the sample. Thanks to its design, the instrument can be adapted to the diameter of the mandrel used are bent perfectly and regularly over the mandrels

Elasticity and resitance to deformation are part of the key physical properties required in the coatings industry. Essentially there are three different test methods which are used to determine a coating\'s performance under different deformation conditions.

Bend Test A coated metal sheet is bent over a cylindrical or conical mandrel and the coating observed for cracks and discolouration.

This cylindrical mandrel bend tester consists of a robust frame which has a bending lever, with height adjustable rollers and a sliding vice for the sample. Thanks to its design, the instrument can be adapted to the diameter of the mandrel used are bent perfectly and regularly over the mandrels

Cylindrical Mandrel
: The test plates are bent progressively over mandrels of decreasing diameter until cracks appear. It incorporates mandrels of the following diameters: 2, 3, 4, 5, 6, 8, 10, 12, 16, 20, 25 and 32 mm.

References

Referencia Description Quotation Request
0305100 Cylindrical Mandrel (ISO 1519) - Bend Tester Quotation Request
Contact us

Downloads

Standards

UNE EN ISO 1519, ASTM D522-B, DIN 53152.

Maintenance service and calibration

Contact us

Contact us

We are here to help you. Please call or write us an email.

Commercial
+34 943 82 00 82
Tech support
+34 943 82 07 90
Email

Ask us about Cylindrical Mandrels